Version 8 (modified by wade, 11 years ago) (diff) |
---|
無線網路設定
- WPA 密碼設定:
- 設定檔:/etc/network/interfaces
# allow-hotplug wlan0 iface wlan0 inet manual wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf iface default inet static address 10.1.2.20 netmask 255.255.255.0 network 10.1.2.0 gateway 10.1.2.1
- 使用 DHCP 設定 IP:
# allow-hotplug wlan0 iface wlan0 inet manual wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf iface default inet dhcp
- 手動設定 IP 設定檔:/etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev update_config=1 network={ ssid="Your SSID Here" proto=RSN key_mgmt=WPA-PSK pairwise=CCMP TKIP group=CCMP TKIP psk="YourPresharedKeyHere" }
- 重新啟動無線網路。
# sudo ifdown wlan0 # sudo ifup wlan0 ioctl[SIOCSIWAP]: Operation not permitted ioctl[SIOCSIWENCODEEXT]: Invalid argument ioctl[SIOCSIWENCODEEXT]: Invalid argument
- 觀看無線網路狀態:
# iwconfig lo no wireless extensions. eth1 no wireless extensions. wlan0 IEEE 802.11bg ESSID:"Your SSID Here" Nickname:"<WIFI@REALTEK>" Mode:Managed Frequency:2.442 GHz Access Point: NN:NN:NN:NN:NN:NN Bit Rate:54 Mb/s Sensitivity:0/0 Retry:off RTS thr:off Fragment thr:off Power Management:off Link Quality=100/100 Signal level=95/100 Noise level=0/100 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 eth0 no wireless extensions.
- 設定檔:/etc/network/interfaces
套件
- webcam:
- http://gsyan888.blogspot.tw/2013/04/raspberry-pi-webcam-server.html
- http://pingbin.com/2012/12/raspberry-pi-web-cam-server-motion/
- 設定檔:
#lsusb 看是否抓到 webcam #sudo vim.tiny /etc/motion/motion 設定 daemon : 設定為 on webcam_localhost : 設定為 off #sudo vim.tiny /etc/default/motion start_motion_daemon=yes
- 啟動:
#sudo service motion start
- 觀看服務狀態:
#netstat -na | grep 8081 tcp 0 0 0.0.0.0:8081 0.0.0.0:* LISTEN
- 於 browser 中輸入「http://192.168.2.1:8081」即可觀看